Outbound Fax with ATA


In the world of VoIP, voice is first converted into packets and then they are sent over the connections that make up our our vast Internet.  They may take slightly different times to arrive at their destination.  In doing so some packets may be discarded, but the end result is that the receiving VoIP device has enough packets to make a clear and understandable voice conversation.

However, fax machines listen for specific tones that then are converted into the fax data.  We suggest these settings on a fax machine for faxing over VoIP; slowing the transmission rate down and allowing the machine to continue receiving the transmission even though a few bits of data were lost, then faxing over VoIP can become more consistent.  Our suggestions in many cases can resolve issues that prevent faxing over a VoIP connection, but not in all cases.  If after trying and making all the VoIP fax changes we suggest you still cannot fax over your connection then try using our eFax service (which is free with most accounts).

You will want to make these changes:

Slow down the transmission speed. 

    • Set the BAUD rate of the fax machine to 9600 bps or even lower (7200 bps would be the next slower setting).
    • Turn off or disable ECM (error correction mode), a setting, usually defaulted on, that many fax machines have.
  • Fax over IP, Faxing over VoIP, FoIP
  • 0 Users Found This Useful
Was this answer helpful?

Related Articles

Disabling SIP ALG

Disabling SIP-ALG is an essential part of setting QoS on a router and optimizing it for your...

Hard Reset GXV3275

If you cannot access web GUI for factory reset, or when the GXV3275 cannot bootup, follow the...

Factory Reset Polycom Phone without Admin Password

The default password for Polycom phones is '456', if that is not working correctly, you may need...

Adjusting Netgear Routers to Support VoIP

Netgear ships their routers so that out of the box they rewrite SIP (VoIP) packets due to their...